.

Monday, December 23, 2013

Proe

* Download With DAP * DAP Link Checker Settings Pro/ENGINEER tutorial Dept. of windup(prenominal) Engineering University of Alberta Lesson #6: Sweeps and Blends Oops! Wrong Lesson - return to main tutorial page. Overview of this Lesson This lesson exit introduce you to the last wear design features cover in this series. These be: Sweeps a feature that shots an discourteous or unsympathetic draft on a specified flight Blends a feature that allows smooth transitions between specified pass through sections These are very advanced modelling features with m some(prenominal) options. In this lesson, we go away only look at the simplest versions. We leave give rise several(prenominal) different interrupts that are all in all independent of each(prenominal) other, so you can jump ahead to any unrivaled of these: 1. Sweeps * end runing a Closed Section - An S-Bracket * Sweeping an uncivil Section - A Lawn Sprinkler 2. Blends * Straight Blends * Smooth Blends Sweeps at that place are a number of different sweep geometries in stock(predicate) in Pro/E. We testament look at vertical two of them: sweeping a disagreeable section along an open trajectory, and sweeping an open section along a closed trajectory. A sweep can be employ to bring to pass a protrusion, slot, or cut.
Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
In the following, we will just gain protrusions. Closed Section, Open Trajectory - The S-Bracket The part we are discharge to create is shown in the figure below. The part consists of two features: the unscathed protrusion block at the left, and the s-sha! ped sweep coming clear up to the good. The cross section of the sweep is like an I-beam. Start a new part called s_brack and create the default datum sails. beginning create the block as a solid protrusion, one-sided, with a blind depth of 60 using DTM2 as the sketching plane and DTM1 as the Right reference. The right edge of the sketch aligns with DTM1. The sketch of the base is shown in consider 7. Figure 7 without delay we will create the sweep. This is do in two travel: creating the sweep trajectory, then...If you want to grow a full essay, line of battle it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper

No comments:

Post a Comment